Auto Lap Counter Monitor [hLapMonitor]

Monitor laps completed around any course -- * New Pacer feature * Advanced UI version of hLaps www.hsoftware.info donate https://paypal.me/hsoftware The Data Field has been designed to count the number of laps completed around any course, loop or circuit based on a start location and not a fixed distance. The counter uses your GPS location to determine how many laps have been completed and therefore can be used on any course. The Data Field will constantly check your location against the start point. Each time you reach the start point, the number of laps will be increased. A new feature allows you to decrement from a set number of laps. To handle the inaccuracy of any GPS reading, the Data Field will increase laps once you are in a start zone. The default start zone is within a 15 metre radius and will only check again which you've exceed twice this distance. If the course naturally crosses within the start zone after the start, the data field will accidentally increase the number of laps. Therefore reduce the start zone to a smaller value. Please note a poor GPS signal could impact the calculation. The Lap information recorded in the Garmin FIT File will match your standard device setting, and the not that calculated by the Data Field. However the Data Field will also add the record Lap information to the FIT File. The Data Field will also now show the estimated lap time, based on when you cross the start location. Due to GPS readings, this needs to be estimated, and used as a guide only. Above the main field, there is now a progress bar. It shows a red bar when you are progressing inside the start zone. A purple bar (first lap only) to show your distance from the start, as a guide. A green bar (from second lap) to show a percentage complete of the lap. The Data Field can be configured to: - Start Radius: Change the number of metres on which the start is determined as being within. Default 15 metres. - Decrement Laps: Decrement a number of laps, rather than increment. A value of zero (default) will increment. - FIT Recording: Turn on or off the FIT recording of laps. This can save battery and save when using the Smart Recording device setting. - Lap Estimates: The number of seconds to display the lap estimate. This can be also switched off. Default is 10 seconds. - FIT Estimates: Turn on or off the FIT recording of time estimates. This can save battery and save when using the Smart Recording device setting. Only 32 characters can be saved, so once this limit has been reached, it will save your Fastest - Average - Slowest lap times with the lap number. A graph of the estimated lap times will also be stored. - Vibrate: Turn on the device vibrate when either entering or exiting the start zone. - Remove outlying times from summary: Removes any lap times (but not the lap count) which are ±20% of the average from the FIT summary. - Distance Complex: Shows either feet or metres from the start on small distances; then switches to the main unit. Otherwise shows a simple number. - Field Option 1: When the display allows for a third line, you can select from a number of options. - Predicted Mode: Use Average (default), Current or Recent speed, in the predicted mode. - Pacer Distance: Mark distances to check pace against the previous lap. The progress will show a blue for slower or red for faster progress. See the following link for more details http://bit.ly/1ODbOOp Please Note: The Data Field should only be used as a guide, and if the number of laps completed is critical to any event or competition, hSoftware is not responsible for any inaccuracy in the data. Please note that no warranty or liability is accepted for the download or use of this product, or any injury, loss or damage caused by its installation or operation.

Version 7.0 (28/Jul/26): - Done: Add Pacer to compare against segments (Major Case 02066) - Done: Update start screen to reflect layout (Minor Case 02063) - Done: Add support for D2 Mach 2 Pro, Forerunner 170, Forerunner 170 Music & Forerunner 70 (Minor Case 02068) - Done: Remove support for D2 Bravo Titanium (Minor Case 02069) - Done: Change Start Page showing Radius (Trivial Case 02064) - Done: Upgrade Platform SDK to Version 9.2.0 (Trivial Case 02070) Version 6.5 (10/Mar/26): - Done: Improve FIT file recording (Minor Case 01883) - Done: Add support for D2 Mach 2, Edge 550, Edge 850, eTrex Touch, Fenix 8 Pro, GPSMAP H1, Instinct Crossover AMOLED, Venu 4 41MM & Venu 4 45MM (Minor Case 01976) - Done: Upgrade Platform SDK to Version 8.4.1 (Trivial Case 01977) Version 6.4 (26/Jun/25): - Done: Add support for 570-42, 570-47, 970, AppS50, DesG2, End3, Fn8-43, Fn8-47S, Fn8-51, Fn8-51S, FnE, Inst3-45, Inst3-50, Inst3S, InstE-40, InstE-45, MTB, VA6 & VenuX1 (Minor Case 01858) - Done: Remove support for D2 Bravo, Forerunner 230, Forerunner 235, Forerunner 630 & Oregon 7 Series (Minor Case 01859) - Done: Upgrade Platform SDK to Version 8.2.1 (Trivial Case 01860) Version 6.3 (27/Aug/24): - Done: Add support for Edge 1050 & Fenix 7 Pro Solar (Minor Case 01697) - Done: Remove support for (Minor Case 01698) - Done: Upgrade Platform SDK to Version 7.2.1 (Trivial Case 01699) Version 6.2 (09/Mar/24): - Done: The lap counter stopped working recently (Blocker Case 01583) Version 6.1 (05/Mar/24): - Fix: Fenix 5 progress bar overlaps data (Major Case 01575) - Done: Add support for Forerunner 165 Music & Forerunner 230 (Minor Case 01576) - Done: Upgrade Platform SDK to Version 6.4.2 (Trivial Case 01577) Version 6.0 (05/Jan/24): - Done: Add Current Lap Pace as a custom option (Major Case 01566) - Done: Add Last Lap Pace as a custom option (Major Case 01567) - Done: Add Last Lap Time as a custom option (Major Case 01568) - Done: Add support for Descent Mk3 43MM, Descent Mk3 51MM, Fenix 7 Pro Solar & Fenix 7X Pro Solar (Minor Case 01571) - Done: Upgrade Platform SDK to Version 6.4.1 (Trivial Case 01572) Version 5.0 (27/Nov/23): - Done: Add predict lap time as a field option (Major Case 01552) - Done: Show Field Option Label on first lap (Major Case 01553) Version 4.0 (23/Nov/23): - Done: Full Screen Version (Major Case 01531) - Done: Add progress bar (Major Case 01532) - Done: Add custom field choice (Major Case 01541) - Done: Add support for 265, 265S, 540, 840, 965, AppS7042, AppS7047, EpPro42, EpPro47, EpPro51, Fn7Pro, Fn7SPro, Fn7XPro, GPS67, Inst2X, InstX, VA5, Venu3 & Venu3S (Minor Case 01542) - Done: Upgrade Platform SDK to Version 6.3.1 (Trivial Case 01543) Version 3.4 (21/Dec/22): - Done: Add support for Edge Explore 2, MARQ 2, MARQ 2 Aviator, Venu Sq 2 & Venu Sq 2 Music (Minor Case 01422) - Done: Upgrade Platform SDK to Version 4.1.5 (Trivial Case 01423) Version 3.3 (24/Jun/22): - Done: Add support for D2 Mach 1, Descent G1, Edge 1040, Forerunner 255, Forerunner 255 Music, Forerunner 255S, Forerunner 255S Music, Forerunner 55, Forerunner 630 & Forerunner 955 (Minor Case 01343) - Done: Upgrade Platform SDK to Version 4.1.4 (Trivial Case 01344) Version 3.2 (16/Mar/22): - Done: Add support for D2 Air X10, Descent Mk2S, Epix 2, Fenix 7, Fenix 7S, Fenix 7X, Forerunner 745, Forerunner 945 LTE, Instinct 2, Instinct 2S, Venu 2 Plus & Venu 2S (Minor Case 01303) - Done: Upgrade Platform SDK to Version 4.0.9 (Trivial Case 01304) Version 3.1 (26/May/21): - Done: Add support for D2 Air, D2 Bravo, D2 Bravo Titanium, Descent Mk2, Enduro, Venu 2, Venu 2S, Venu Sq & Venu Sq Music (Minor Case 01214) - Done: Upgrade Platform SDK to Version 4.0.1 (Trivial Case 01215)